![]() Rig control requires a cable and a rig that supports it, and isn't necessary for the activities covered in this course. ![]() The frequency display and mode indicator become active and potentially useful only when you are using rig control, which enables fldigi and the rig to communicate information back and forth and allows fldigi to control the rig beyond merely initiating and ending transmission. In fldigi's default view, there are some additional features at the top, including a frequency display (by default you'll see "0.000") and mode indicator at the left side. On frequencies that aren't busy with multiple signals visible in the waterfall, this pane will probably not be useful to you. To the left of the receive and transmit panes, you may see the channels pane, with a white background by default. Confirm this by ensuring that the button just below the lower left corner of the waterfall pane reads "WF" if it does not, click it until it does.) (This pane can actually display things other than the waterfall, but this training course will assume you are seeing the waterfall. As seconds pass, each signal appears at the top of the waterfall and disappears at the bottom. Here, incoming and outgoing digital signals are displayed. Below the transmit pane, with a black background by default, is the waterfall pane. It will display in black any text that is set up to be transmitted and in red any text that has already been transmitted during the current transmit session. Below the contact pane, with a pale blue background by default, is the transmit pane. It retains that text during your current fldigi session but is erased when you close fldigi (though it is saved in your log files). It will show pretty much everything that happens during your fldigi session, including text you have received and text you have transmitted. The upper large horizontal pane, with a pale yellow background by default, is the receive pane (or contact pane). (Your copy of fldigi may look a little different the user interface can be modified in many ways!) Note the three large horizontal panes and one vertical pane: Except maybe 119 and 120Ĭhannel 119 is the US APRS Frequency, the pl tone is for Voice AlertĬhannel 120 is the Maine ARES Packet Frequencyġ05 Livermore 146.895 - TSQL 103.5 Limited Rangeġ09 FARM180 147.180 + Tone 123.0 LITCH 146.700 - Tone 100.0 **** Note: Now a DMR Repeaterġ23 NORWAY 147.120 + Tone 136.5 ***W1OCA linked to W1IF Buckfield 224.620 - Tone 103.Now, with any interface device and cables disconnected from your computer, launch fldigi as you would any other newly-installed application. The essential Androscoggin ARES/RACES Frequencies are in the range of 101 and 122 in generally decreasing order of importance. The duplicates in the range of 101 to 128 are intended to be for the most important local frequencies, so they will be close together for quick switching and to provide a list to put in radios with limited number of memory channels. The list did have the repeaters in frequency order but over time frequency/tones change. My chirp csv file for my Kenwood TH-F6A NOTE:I have some 220 MHz, Marine and Lewiston/Auburn area public safety frequencies in the file too.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |